This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
workflows [2017/03/14 15:04] – [Working with static scapula positions for elevevation angles bigger than 90 degrees] oliver | workflows [2018/07/10 12:02] (current) – [Autodetect humeral elevation phases] oliver | ||
---|---|---|---|
Line 8: | Line 8: | ||
=====Working with static scapula positions for elevation angles bigger than 90 degrees===== | =====Working with static scapula positions for elevation angles bigger than 90 degrees===== | ||
+ | =====Autodetect humeral elevation phases ===== | ||
+ | A common situation is that multiple repetitions of humeral elevation are saved in the same trial. You want to extract them to show time-normalized curves of elevation only. So you want to create phases of elevation automatically. How this can be done is shown in the documentation of the modelling element < | ||
+ | With a maximum of 90 degree of elevation typically skin motion artefacts are less. If you have measurements from patients, than in can be happen that they can not elevante their arms up to 90+10=100 degree. That´s why the maximum value is configurable in the model V1.5: | ||
+ | |||
+ | |||
+ | <code xml> | ||
+ | < | ||
+ | | ||
+ | | ||
+ | | ||
+ | <Event name=" | ||
+ | | ||
+ | <!-- die 40 hat sich bei RCycleMaxElevation=90 bewaehrt, bei cylcMaxElevation=60 muss das vielleicht um 10 reduziert werden --> | ||
+ | <Phase name=" | ||
+ | | ||
+ | | ||
+ | | ||
+ | <Event name=" | ||
+ | | ||
+ | |||
+ | <!-- RShoulderEleDepHDCalDirCosAngle < RCycleMaxElevation --> | ||
+ | <!-- limit always to 90 degree instead to RCycleMaxElevatio--> | ||
+ | <Phase name=" | ||
+ | | ||
+ | | ||
+ | | ||
+ | </ | ||
+ | |||
+ | RElePhase is limited to 90 degree even if RCycleMaxElevation is smaller, e.g. 60 degree. If you plot phases | ||